AEC-7923H is a IDE-to-SATA II bridge that mainly converts your SATA hard drive or CD/DVD drive into ATA interface. The newer generation of ACARD IDE-to-SATA II bridge supports SATA I/II device. The great compatibility and low cost makes AEC-7923H become an easy solution for PC users to transform the existing SATA I/II devices to ATA HDD or ATA ODD.
No driver needed LED indicator to display One PATA port for host (use a short, flex 40-pin, 80-conduct, ATA cable to connect IDE port) Easy to install and use Supports PIO mode 0 to 4
ACARD IDE-to-SATA Bridge Controller One 7-pin internal SATA port for device (Vertical SATA connector with latch key and metal cover) High-efficiency IDE transfer (ATA 133MB/sec) Power requirement: 5V Support 48-bit LBA addressing mode ("Big Drive" Technology) ATAPI packet command set Supports Ultra DMA mode 0 to 6 with data rate up to 133MB/sec Serial ATA 1.5G/3G selective jumper on-board