StcHeader
ACARD Technology
RAIDON  Technology Inc.
Seventeam Electronics.
Vinpower Logo-2013
netstor
Highpoint
prowarelogo

 

ST-450BKV

ST-352UAG

INPUT CHARACTERISTICS:

 VOLTAGE

 90 ~ 264 VAC

 FREQUENCY

 50 ~ 60 HZ

 INPUT CURRENT

10.0 A (RMS) FOR 115 VAC / 6.0 A (RMS) FOR 230 VAC

 INRUSH CURRENT

 80 A MAX

ST-352UAG

SPECIFICATION :

EFFICIENCY

67% TYPICAL, FULL LOAD CONDITION AT 115/230 VAC INPUT.

POWER GOOD SIGNAL

ON DELAY TIME 100 ~ 500 ms, OFF DELAY TIME 1ms.

HOLD UP TIME

17ms AT 25C FULL LOAD CONDITION AT 115/230 VAC INPUT.

OPERATING TEMPERATURE RANGE

0c ~ 50c

REMOTE ON/OFF CONTROL

THE POWER SUPPLY OUTPUT SHALL BE ENABLED WITH AN ACTIVE-LOW TTL SIGNAL. WHEN TTL SIGNAL IS LOW, THE DC OUTPUTS ARE TO BE ENABLED. WHEN TTL SIGNAL IS HIGH OR OPEN CIRCUITED, THE DC OUTPUTS ARE TO BE DISABLED.

OVER POWER PROTECTION

AT 115/230 VAC INPUT THE POWER SUPPLY WILL SHUT DOWN ALL DC OUTPUT WITH IN 105% ~ 140% OF FULL LOAD.

OVER VOLTAGE PROTECTION

:+5V ~ 6.5V, +12V ~ 14.5V, +3.3V ~ 4.5V.

EMI REQUIREMENT

FCC PART 15 SUB PART J CLASS B AT SYSTEM LOAD, CISPR 22 CLASS B, CE, BSMI.

SAFETY

UL+C, TUV, CCC

DIMENSION

200 (D) x 100 (W) x 69 (H) mm.

COOLING

 TWO 60mm DC FAN

PASSIVE POWER FACTOR CORRECTION

EN 61000-3-2: 1995+A1+A2: 1998, CLASS D.(FOR 230V ONLY)

OUTPUT CHARACTERISTICS:

OUTPUT VOLTAGE

OUTPUT CURRENT

REGULATIONLINE

OUTPUT

MIN [A]

MAX [A]

LOAD

LINE

RIPPLE MAX [P-P]

NOISE MAX [P-P]

+5V

1

25

+/- 5%

+/- 1%

50mV

50mV

+12V

1

25

+/- 5%

+/- 1%

120mV

120mV

+3.3V

0

17

+/- 5%

+/- 1%

50mV

50mV

-12V

0

0.5

+/- 5%

+/- 1%

120mV

120mV

+5VSB

0

2.0

+/- 5%

+/- 1%

50mV

50mV

1.

MAXIMUM CONTINUOUS COMBINED LOAD ON +5V AND +3.3V OUTPUTS SHALL NOT EXCEED 125W

2.

MAXIMUM CONTINUOUS COMBINED LOAD ON +5V, +3.3V AND +12V, OUTPUTS SHALL NOT EXCEED 334W.

3.

MAXIMUM CONTINUOUS TOTAL DC OUTPUT POWER SHALL NOT EXCEED 350W.

Copyright © 2010 by STC Computech Co; Ltd.. All rights reserved.